Pace makes digital set-top boxes for a variety of pay-TV market service providers, such as Comcast Cable. When you subscribe to a cable service, your set-top box is often installed by the cable provider's technician. If you need to disconnect your Pace set-top box, you don't need to call your cable technician to reconnect the box. You can perform this on your own.
Setup Using A/V Cables
Video of the Day
Step 1
Connect the coaxial cable wire coming from the wall, this cable carries the main cable TV signal, into the RF-in connector labeled "Cable In" on the back of the Pace set-top box.
Video of the Day
Step 2
Plug one end of the red A/V cable into the red "R" "Audio Out" jack on the back of the Pace set-top box. Plug one end of the white A/V cable into the white "L" "Audio Out" jack on the back of the Pace set-top box. Plug one end of the yellow A/V cable into the yellow "Video Out" jack on the back of the Pace set-top box.
Step 3
Follow the same pattern as you connect the other end of each A/V cable to an A/V-in panel on the TV.
Step 4
Plug the TV's power cable into the "Power Outlet" on the back of the Pace set-top box.
Step 5
Connect the power cable, which came with the Pace set-top box, to the "Power Input" port on the back of the set-top box. Plug the set-top box's power cable into a power strip or wall outlet.
Step 6
Switch on the TV. Use the "Input" button on the TV's remote control to change the video input channel on the TV to the appropriate A/V source.
Setup Using Coaxial Cable
Step 1
Connect the coaxial cable wire coming from the wall, this cable carries the main cable TV signal, into the RF-in connector labeled "Cable In" on the back of the Pace set-top box.
Step 2
Screw one end of the independent coaxial cable wire into the RF-out connector labeled "To TV" on the back of the Pace set-top box. Screw the other end of this cable into the "RF In" connector on the back of the TV.
Step 3
Plug the TV's power cable into the "Power Outlet" on the back of the Pace set-top box.
Step 4
Connect the power cable, which came with the Pace set-top box, to the "Power Input" port on the back of the set-top box. Plug the set-top box's power cable into a power strip or wall outlet.
Step 5
Switch on the TV and tune it to Channel 3.